- Products
-
- MED CRANK PULLEY LOCK PLATE
MED CRANK PULLEY LOCK PLATE
Description
The MED crank pulley locking plate is laser cut from stainless steel to suit the range of MED crankshaft dynamic damper/pulleys.
This is the most secure method of holding the crankshaft damper bolt in place.
Fitting instructions:
1 - Fit crankshaft damper assembly.
2 - Apply 27-01 thread lock and torque MED crankshaft bolt to 70lb/ft.
3 - Remove four cap head screws from crank pulley.
4 - Install locking plate.
5 - Apply thread lock and torque cap head screws to 10lb/ft.
Remember to reassemble a balanced crank damper assembly in the same position to retain an accurate balance.
Frequently Asked Questions
Where does this fit on an A-Series engine?
This laser-cut plate fits over the MED crankshaft pulley bolt (MED-1410-CB) as a belt-and-braces lock tab for the S pulley kit. The plate fits over the bolt head, while 5/16" UNF screws hold it all in place.
Do you have a picture of how it fits?
Yes, please check the images above.
Does this fit a standard crankshaft pulley?
No, only the MED two-piece setup.
Related Products
CRANKSHAFT WOODRUFF KEY
MED DAMPER PULLEY BOLT
MED DYNAMIC CRANK DAMPER RING
MED LARGE ALTERNATOR PULLEY
MED S DAMPER KITS
MED S PULLEY - STANDARD
MED S PULLEY MANAGEMENT - FLAT
MED S PULLEY MANAGEMENT TYPE
MED VERNIER CAMBELT DRIVE
